Reference electrode Luggin Tube

Variable speed motor

High impedance voltameter

Electrolyte level

Plexiglas cylindrical container

Stainless steel cylindrical anode (+ve)

Multi impeller cathode (-ve)

A Multi range ammeter

voltmeter

12 volt  d.c. power supply

Fig. 1 –  Cell and electrical circuit.

Fig. 2 –  Three dimensional diagram of the proposed impeller.

used (Fig. 3); the apparatus consisted of 20 L plastic storage tank, 0.33 horse power plastic centrifugal pump and the cell. A by-pass was used to regulate the solution velocity in the cell; all valves were made of plastic.

The electrical circuit consisted of 12 V d.c. power supply with a built-in voltage regulator connected in series with a multi-range ammeter and the cell. Before each run the cell was filled with the solution (2650 cm3) and the rotational speed of the impeller was adjusted at the required value. The  limiting

Fig. 3 –  Apparatus used in case of continuous operation.

current of the cathodic reduction of K3Fe(CN)6 at the impeller cathode was determined by increasing the current stepwise and measuring the corresponding cathode potential   against a reference electrode by means of a digital high impedance voltmeter until the limiting current plateau was obtained. The reference electrode consisted of a nickel wire placed in the cup of a glass luggin tube filled with the cell solution; the tip of the luggin tube was placed at a distance 0.5–1 mm from the rotat- ing impeller surface (Fig. 1). For the continuous operation of the cell at a certain impeller speed, solution was introduced to the cell from the storage tank at the required velocity by means of the centrifugal pump; solution velocity was mea- sured volumetrically by means of a graduated cylinder and a stopwatch. Table 1 summarizes the range of variables studied in the present work. In order to change Sc, the physical proper- ties (p, µ and D) of the solution were changed by changing the concentration of the NaOH supporting electrolyte (Berger and Hau, 1977). All NaOH concentrations used in the present work are sufficient to eliminate mass transfer of the ferricyanide

Table  2 – physical properties of the ferri/ferrocyanide system at    25 ◦ C.

Solution composition p  (g/cm3 ) µ × 102 (Po) D × 106 (cm2 /s) Sc

0.025 M K3 Fe(CN)6 + 0.1 M K4 Fe(CN) + 1 N NaOH 1.054 1.2236 6.693 1735

0.025 M K3 Fe(CN)6 + 0.1 M K4 Fe(CN) + 2 N NaOH 1.084 1.489 5.508 2494

0.025 M K3 Fe(CN)6 + 0.1 M K4 Fe(CN) + 3 N NaOH 1.1236 1.964 4.335 4032

Table 3 – physical properties of CuSO4–H2SO4  system at 25 ◦ C.

Solution composition p  (g/cm3 ) µ × 102 (Po) D × 106

上一篇:单螺带桨叶与双螺带桨叶的在搅拌器英文文献和中文翻译
下一篇:超声雾化器英文文献和中文翻译

双位错叶片涡轮桨搅拌釜英文文献和中文翻译

单螺带桨叶与双螺带桨叶...

固液搅拌罐的CFD模拟英文文献和中文翻译

固定床反应器中催化剂孔...

搅拌和搅拌反应釜英文文献和中文翻译

磁力搅拌器英文文献和中文翻译

高压釜设计英文文献和中文翻译

AES算法GPU协处理下分组加...

压疮高危人群的标准化中...

上海居民的社会参与研究

浅论职工思想政治工作茬...

基于Joomla平台的计算机学院网站设计与开发

浅谈高校行政管理人员的...

STC89C52单片机NRF24L01的无线病房呼叫系统设计

酵母菌发酵生产天然香料...

提高教育质量,构建大學生...

从政策角度谈黑龙江對俄...