Fig。 3。  Isothermal surfaces at Tsup = 17 °C。

and the RAG have a little variation and maintains at about 61% and 87%, respectively。 However, as air temperature increases at con- stant relative humidity, the air moisture content increases。 In other words, it will lead to an increase of latent heat load or electricity consumption inputted into the VORDC。 Fig。 6 shows the variations of electricity consumption both of the HVAC and the VORDC with the  DSAT。  When  the  DSAT  increases  from  16 °C  to  19 °C,    the

Fig。 4。  Temperature field under different supply air   temperature。

X。  Wu  et al。 / International Journal of  Heat and  Mass Transfer 87 (2015)    685–692 689

Table 2

Temperature and relative humidity variations with   Tsup。

Fig。 5。  Comparison of NIR for different supply air temperature,   Tsup。

Fig。 8。  Comparison of products temperature on the second shelf for different   Tsup。

The products temperature is a crucial parameter in controlling the hazard of bacterial development [32]。 In the VORDC, the major- ity of maximum temperature packs (97%) are located at the front of the cabinet, the largest number (60%) being at the front of the base论文网

of the cabinet [33]。 In this paper, the front products on the  second

shelf are predicted in shelf-scale model。 The specific location of

(b)HVAC

Fig。 6。 Electricity consumption of HVAC and VORDC for different supply air temperature, Tsup。

electricity energy input in VORDC system increases 6。36%。 Meanwhile, as is described in Eq。 (8), the HVAC cooling load or electricity consumption decreases。

products is shown in Fig。  7。

From Fig。 8, it can be seen that the DSAT will obviously influ- ence the products temperature。 When the supply air temperature increases from 16 °C to 19 °C, the maximum difference of products is 0。18 °C。 In addition, the temperature of products gradually increases from both sides to the middle due to the effects of exter- nal conditions of VORDC, as is shown in Fig。   9。

690 X。  Wu  et  al。 / International  Journal  of  Heat  and  Mass  Transfer  87  (2015)      685–692

Fig。 9。  Temperature field at H = 0。92 m in shelf-scale  model。

3。2。Influence of diffuser supply air    velocity

As reported in other studies, the infiltration heat transfer rate is also related to the magnitude and the direction of ambient air velocity [2]。 Therefore, the influence of the DSAV of HVAC should be considered。 In the supermarket-scale simulations, it is found that there are two vortexes between air curtain of VORDC and air flow from the diffusers, as is shown in Fig。  10。 At the  interaction of the vortexes, the HVAC system will affect the ambient condition of VORDC。

Table 3 shows the influence of the DSAV of HVAC on the air temperature  and  humidity  of  measurement  point  and  RAG    of

VORDC。 From the results of supermarket and cabinet-scales computation, the temperature and relative humidity in the    ambi-

ent conditions and at the RAG both decrease with the increase of air velocity from the diffusers due to its lower temperature and moisture  content。  When  the  DSAV  increases  from  3。0 m/s     to

3。5 m/s, the decline trend of the temperature and relative humidity is smaller or of no change。 The reason that, with the increase of DSAV (i。e。 provided cool capacity), the indoor air temperature   will

上一篇:柴油机碳烟氧化英文文献和中文翻译
下一篇:基于约束的纸箱折叠仿真英文文献和中文翻译

AngularJS技术介绍英文文献和中文翻译

开关电源水冷却系统英文文献和中文翻译

减数分裂和基因重组英文文献和中文翻译

太阳能最大功率点追踪和...

移动码头的泊位分配问题英文文献和中文翻译

虚拟船舶装配集成建模方...

中学生科学探究中对等论...

AES算法GPU协处理下分组加...

酵母菌发酵生产天然香料...

提高教育质量,构建大學生...

STC89C52单片机NRF24L01的无线病房呼叫系统设计

浅论职工思想政治工作茬...

上海居民的社会参与研究

基于Joomla平台的计算机学院网站设计与开发

从政策角度谈黑龙江對俄...

压疮高危人群的标准化中...

浅谈高校行政管理人员的...