Abstract: The condensation in pneumatic system is a complex physical phenomenon dependant upon status variation and phase transitions, which are related to the parameters of the compressed air, atmospheric conditions and the dimensions of the pneumatic components。 Up to now, general research method for this problem is to calculate the status variation and movement quantity by numerical simulation and experiment directly。 The comprehensive parameters composed of several different effect factors are rarely used to study the condensation。 The composed components and the working conditions of each cylinder are different, a large number of experiments and complex calculations are necessary to determine the condensation。 Additionally, the transferability of the determined results is poor。 In this paper, the charging and discharging systems of serials cylinder with different structure parameters are studied。 The condensation of the systems is observed and the effects of the structure parameters on condensation are analyzed。 The changing trends of relative humidity, natural frequency and average speed against the structural parameters of the components during discharge of the pneumatic systems are analyzed。 Three comprehensive parameters used to analyze and determine condensation composed by structure parameters of components are proposed, namely, the ratio of the effective area of the discharge tube and the container volume, the square root of the effective area of the discharge tube pided by the product of the container volume and the length of the discharge tube, and the discharge dimensionless tube-volume。 The experimental results show that these comprehensive parameters can be used to quantitatively determine whether internal, external or zero condensation occurs in a pneumatic system, and can be also used to quantitatively analyze the experimental data of condensation in pneumatic systems directly。 At the same time, the effect factors are too much and the effect relationships are very complex, which causes that the conclusions can’t be put forward by using single effect factor in experimental data processing inpidually。 The three obtained comprehensive parameters can be used to resolve the above problem。 The proposed parameters can also resolve the problem of poor transferability in determining the state of condensation in pneumatic systems, and provide a novel method for the further study of condensation theory。71999

Key words: pneumatic system, condensation, comprehensive parameter, structure parameter

1 Introduction

In pneumatic system, cooling caused by the expansion of compressed air will produce water droplets,  which  is known as condensation。 If water droplets occur inside a component, the phenomenon is called internal condensation。 Contrarily, it is called external condensation[1]。

Former research shows that condensation in pneumatic systems is closely related to the state and  motion parameters of the compressed air。 The condensation is effected by the system operating condition, the structural parameters of the pneumatic components, the initial status of the compressed air and the atmospheric conditions。

The condensation in pneumatic system was proposed by WANG[1–2] firstly, during his work at SMC in Japan。 Based on a large number of experiments, the condensation was pided     into     internal     condensation     and     external

* Corresponding author。 E-mail: zczhu@zjinfo。gov。cn

This project is supported by National Natural Science Foundation of China (Grant No。 50575209 )

condensation, The mechanisms of condensation in a pneumatic system was analyzed, and the impact trend of parameters, such as supply pressure, dew-point temperature, inner volume of cylinder, the length of the discharge  pipe on pneumatic condensation, were presented。

上一篇:混合视觉伺服英文文献和中文翻译
下一篇:系统开发生命周期英文文献和中文翻译

开关电源水冷却系统英文文献和中文翻译

多极化港口系统的竞争力外文文献和中文翻译

机床控制系统英文文献和中文翻译

动力传动系统振动特征英文文献和中文翻译

旋转式伺服电机的柔性电...

电力系统智能波形记录仪英文文献和中文翻译

集成生理传感器系统英文文献和中文翻译

基于Joomla平台的计算机学院网站设计与开发

上海居民的社会参与研究

提高教育质量,构建大學生...

浅论职工思想政治工作茬...

AES算法GPU协处理下分组加...

压疮高危人群的标准化中...

从政策角度谈黑龙江對俄...

STC89C52单片机NRF24L01的无线病房呼叫系统设计

酵母菌发酵生产天然香料...

浅谈高校行政管理人员的...