19。62 MW at 91 r/min。 The auxiliary engines are three four-stroke DEs developing each one  a maximum power of 900 kW。

The ship requirements in seagoing conditions are as follows:

●For the propulsion power demand: engine power at NCR  working  conditions  (90%  of   MCR): 17,658 kW。 This power is required for a ship speed of 16。2 knot at design draught, heavy running (with 15% sea margin) or 16。8 knot at design draught, light running。

●For the electric power demand: the pertinent    data

are reported in Table 2。 On the basis of the ship- owner indications, it has been considered that the ship  will  work  270 days  per  year,  70%  of    that

(189 days)  in  normal  seagoing  condition  and the

remaining 30% (81 days) in normal seagoing with tank heating condition。

●For  the  thermal  power  demand  (service  steam    in 来,自.优;尔:论[文|网www.chuibin.com +QQ752018766-

Figures 1 and 4): thermal users need a saturated steam flow  rate of 1。4 t/h at a  pressure of  at  least 7 bar。 This estimate does not take into account the steam required to heat the load (tank heating)。 This is because such a user requires a steam flow rate of about 35 t/h, therefore incompatible with the steam producible from any heat recovery boiler。

Original WHR plant layout

As mentioned before, the authors’ work starts from the analysis of a WHR plant layout equipped with a typi- cal steam plant,7 basic scheme of which is presented in Figure 1。 Mainly, the DE exhaust gases supply two groups of gas turbines in parallel: the turbocharging set (turbocharger in Figure 1) and a power  gas  turbine (gas turbine)。 The power produced by this last turbine can be used for the generation of additional electric power or to increase the propulsive power。 The exhaust gases of both group of turbines feed a   double-pressure

HRSG, which is the main component of a steam plant for heating services and power production。 The DE jacket water is used to preheat the condensate water coming from the condenser and going to the hot well tank。 The scavenge air compressed by the turbocharger provides heat to the low-pressure (LP) preheater and is subsequently cooled down by the central cooler up to a temperature suitable to enter the cylinders。

上一篇:蜂窝移动通信系统英文文献和中文翻译
下一篇:Co和大幅面质子辐射效应CCD用于地球成像英文文献和中文翻译

柴油机大涡中小火焰模型...

柴油机碳烟氧化英文文献和中文翻译

柴油机缸内润滑油消耗分...

柴油机连杆英文文献和中文翻译

船用柴油发动机的活塞组件英文文献和翻译

酵母菌发酵生产天然香料...

提高教育质量,构建大學生...

上海居民的社会参与研究

浅谈高校行政管理人员的...

压疮高危人群的标准化中...

STC89C52单片机NRF24L01的无线病房呼叫系统设计

从政策角度谈黑龙江對俄...

浅论职工思想政治工作茬...

基于Joomla平台的计算机学院网站设计与开发

AES算法GPU协处理下分组加...