小型网络设计-校园网建设 第3页

小型网络设计-校园网建设 第3页

PC3:192.168.22.9

        Gateaway:192.168.11.11

PC4:192.168.22.7

        Gateaway:192.168.15.11

PC5:192.168.22.8

        Gateaway:192.168.15.19

路由器(Router5)和交换机(S0,S1 ,S2,S9)和网桥(Bridge2)分别的配置命令如下:

交换机的配置命令如下:

C2950 Boot Loader (C2950-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1)

Compiled Mon 22-Jul-02 18:57 by miwang

Switch-PT starting...

Base ethernet MAC Address: 00D0.FF02.5586

Xmodem file system is available.

Initializing Flash...

flashfs[0]: 4 files, 1 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 7741440

flashfs[0]: Bytes used: 6159872

flashfs[0]: Bytes available: 1581568

flashfs[0]: flashfs fsck took 7 seconds.

...done initializing flash.

Boot Sector Filesystem (bs:) installed, fsid: 3

 (c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

X.25 software, Version 3.0.0.

4 FastEthernet/IEEE 802.3 interface(s)

2 Low-speed serial(sync/async) network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Press RETURN to get started!

 

Router con0 is now available

Press RETURN to get started.

System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)

Copyright (c) 2000 by cisco Systems, Inc.

PT1000 platform with 65536 Kbytes of main memory

 

              Restricted Rights Legend

 

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

 

cisco Systems, Inc.

           170 West Tasman Drive

           San Jose, California 95134-1706

 

Cisco Internetwork Operating System Software

IOS (tm) PT1000 Software (PT1000-I-M), Version 12.2(28), RELEASE SOFTWARE (fc5)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2005 by cisco Systems, Inc.

Compiled Wed 27-Apr-04 19:01 by miwang

Image text-base: 0x8000808C, data-base: 0x80A1FECC

pt 1001 (PTSC2005) processor (revision 0x200) with 60416K/5120K bytes of memory.

Processor board ID PT0123 (0123)

PT2005 processor: part number 0, mask 01

Bridging software.

X.25 software, Version 3.0.0.

4 FastEthernet/IEEE 802.3 interface(s)

2 Low-speed serial(sync/async) network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

 

Router con0 is now available

Press RETURN to get started.

Press RETURN to get started!

 

Router>enable

Router#configure terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)#interface FastEthernet0/0

Router(config-if)#no shutdown

%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to down

Router(config-if)#

Router(config-if)#exit

Router(config)#interface FastEthernet1/0

Router(config-if)#no shutdown

%LINK-5-CHANGED: Interface FastEthernet1/0, changed state to down

Router(config-if)#

Router(config-if)#exit

Router(config)#interface FastEthernet4/0

Router(config-if)#no shutdown

 

%LINK-5-CHANGED: Interface FastEthernet4/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet4/0, changed state to up

Router(config-if)#

Router(config-if)#exit

Router(config)#interface FastEthernet5/0

Router(config-if)#no shutdown

 

%LINK-5-CHANGED: Interface FastEthernet5/0, changed state to down

Router(config-if)#

Router(config-if)#exit

Router(config)#interface FastEthernet0/0

Router(config-if)#

上一页  [1] [2] [3] [4] [5] 下一页

Copyright © 2007-2012 www.chuibin.com 六维论文网 版权所有